Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Here is the picture of the hardware I am working on
- - - Updated - - -
I should be done with the hardware hopefully tomorrow, I am currently using 8MHz Crystal Osc. to test.
Please do let me know if its Ok.
Thanks
Thanks so much for the hex file. i should have the schematics soldered by tomorrow to test.
Meanwhile can you send the proteus file to see what is expected of the mcu.
Thanks
Hi,
Your question is why is need a for loop ? is not clear.
The code is meant to do two basic task increment count from 0 - 9999 in the part of code towards the bottom "Count++"
and go back to 0 when count reaches 9999 in the part of code towards the bottom
if(Count > 9999)
Count = 0...
To accurately calibrate for OV an UV I recommend the use of a variac. If you follow my earlier post and use a variac to set the ac voltage btw 200ac - - - - 240ac . Such that if voltage drops below or is above the LED comes on and can thus be inputed into uC
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.