Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everybody,
I have bought a LCD display but I don't know how to connect it to the PIC.
The display is EI62585 ,C20408tr-08 ,050316 (i don't know which number is the moduls' number).
Does anybody has the datasheet of this display or a circuit with PIC16f84?
Thank.
I am using Proteus to simulate my circuits.
I want to simulate a circuit that is bigger then the normal working sheet, and when I try to change the sheet size to A3 for example the program closes.
did anybody encounter this problem?
thanks...
I have been programming with icprog for some time.
I have incountered this week in a problem - when I program a specific program the process stops after programming about half of the code and every time in a different place (for example Error on 0x010C or other place)-there is no problem with...
sawtooth oscillator
I want to build a sawtooth oscillator using only simple components like C,R,L and transistors (preference for bi-polar not Cmos)-no opAmp or 555 or any other chip.
Does anyone has an idea or a circuit diagram for it?
Thanks
icp-rog
What error message do you get?
One thing that worked for me was clicking right click on the icprog icon and then choosing compatability and change and it the "run this program in..."
choose win 2000.
If this doesn't work there can be many other options depending on the error you get...
I am not sure...
If you put '1' to the gate of the N-MOS that is on the top it will open and the output will be '1'.
Same for '0' on the bottom.
Is it right or wrong?
(I can't attach a file for some reason so I rtied to draw)
--- vcc
|...
Hi Guys,
I have a small nice question:
If you take a CMOS inverter (NOT gate) that is constructed from a N-MOS at the
bottom and a P-MOS at the top, and you exchage between the two transistors- will it work as a buffer?
I have attached a picture for visual understanding.
Thanks
Tzviel
I have built the uJDM programmer to use with ICPROG software in order to write PIC16F84A.
(**broken link removed**)
The circuit is correct and I have configured the software as it said on the uJDM site, but when I try to write a file to the PIC, it doesn't write anything, and the PIC stays...
question about PIC
I am just beginning to work with uc.
I have decided to beggin with PIC16F84 because it has a lot of documentation and references.
I need to build and interface between the PIC and the RS-232 connector -I have downloaded some schematics from the web.
and I know I need a...
thank you for your answeres.
It is getting clear,and I think I should start working and get some experience.
I am going to build the programmer circuit, but I still don't know which software I can use to burn the chip.
regards
tzviel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
