Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
just set "f" as a constant,for example the data output boundary size is 7*7*37,so i select f = 50,finally i get the correct result.mybe there is some way to estimate the value of "f",but i did not know.you can try it! good luck!
Added after 7 minutes:
u also could set 'f' as a 'real'...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.