Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i had reprojected door opener with at90can32 and avrstudio and avrgcc and it's very good, now board is better and powerful, now i seach for j1939 sae for spend state/conditions of doors.
to drive SM you have need a driver with a supply 4-30vcc , thera are some IC that maintein konstant current on motors winds.
with this you can drive your motor with 2000-4000 pulse /sec.
How is the connection and scheme on Drivers for Brushless motors to charge capacitors when the motor brake...?? ther's 3 diode that charge line capacitors ..boh?
i maked a bridge with 4 mosfet for DC motor , i control bridge througt MC in pwm and receive encoder A-B signal from axis'motor , now the noise of 25khz disturb too much the encoder's signal and software PID go-out , what must i connect on bridge to protect encoder's signals? thankyou
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
