Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
@Hanskarl2000: So you can read AVRMS?. I haven't test to read AVRMS because i think if i can read wform, I can do well all other module.
I have uncomfortable about the way Analog present this ADE7758 datasheet.
Acording to this page : bit 2 - 4:WAVSEL (default value =0).
So I think bit in red...
I have your same Problem. I have made a test circuit.
to test the voltage I use a transformer from 220v~/9V~ and resistors 25k and 1k. However, when i read the waveform régister
Write1byte(0x15,0x04);//Write to ADE Wavemode register and I check it
//wavemode = 0x04 successfull...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
