Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
I am converting 24v to 12v using a R-7812-0.5 converter, but I have some current sensitive components connected to the 12v circuit. So my question is will this converter always send 500mA, or is that dependent on the current consumption in the circuit? Maybe it’s a stupid question, but I am...
This question is regarding 3-wire 4-20mA current loop transmitting
I have purchased 2 ICs from TI; the XTR 110 and XTR 111
neither of them could transmit the signals i wanted when connected according to the circuits provided in the datasheets.
I researched a bit and found that unlike a 2-wire...
Hello. I have made footprints for a Arduino Mega 2560 R3 in PCB Editor. I want it mounted on the back of the board, but the only solution I know to put it on the other side of the board is to mirror the component. When I do this, the component mirror and drill holes are completely wrong...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.