Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For the past while I have been digging around getting communications working between development boards and computers. There are many examples for using TCP/IP, XBee, Zigbee etc and using them to send and receive data, this is all fine.
Now I get to the point where I want to prototype a light...
I am looking at working with pre made breakout boards and development boards. I would like to be able to document the connection between these as well as the creation of new schematics and PCB's to use with these. For example a STM32VLDiscovery board with a LCD and a new custom H-Bridge board...
Update: I looked into the regulator stability regarding the ESR of the capacitors. My capacitors did not have any readily available spec on ESR (it was electrolytic, so from what I have read it is low) I added 1 and 10 ohms in series with the cap to simulate a higher ESR but the waveform did...
Thanks everyone for the suggestions and information, this post stood out in particular based on what I have read in the last few hours:
I have been reading more about this and I am not even sure that my capacitor does. I did not realize that the capacitor would have that much of an effect on...
I am using a 3.3 Linear Regulator with a 16VDC supply. The regulator is a LD1086V33. I have powered development boards from this with no problems, BUT it will fry all the XBee's I connect to it. The attached image shows the waveform coming out of the regulator when power is connected. I have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
