Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by tongbram

  1. T

    at^siso error with MC55 gsm/gprs module and PIC18F2520

    one of the problem i m thinking is....if more then one system try to access the same server then the possibility of getting error is high. what happen if i try to access the server when it is currently use by other?????????
  2. T

    at^siso error with MC55 gsm/gprs module and PIC18F2520

    ANY ONE........ may be it is due to server which is not responding good enough/traffic congestion in the network or the gsm network in your area is weak. .....................but some time the response is very good but the next day.....sucks.....
  3. T

    at^siso error with MC55 gsm/gprs module and PIC18F2520

    at^siso error hi, what may be the reason for getting continuous error while trying to open gprs connection using at^siso.........when i try to open again without closing the connection using at^sisc, it shows error every time. I m not saying i get error every time when i open but frequency of...
  4. T

    car power supply noise on 12V

    power supply noise hi...i m in serious problem....i m doing a microcontroller based project and my 12 V power supply is very very noisy and it is from the very old fiat car battery. when i start engine on, due to inverted ckt it produces very high ringing noise. The same power supply is the...
  5. T

    Help me with a project that uses Siemens gsm/gprs module

    at gprs siso siss thanks for the reply,.......i m using the socket type of connection. here i can call as well as receives sms but in this type of socket connection i have to disconnect the gprs and then i have to connect the gprs for sending data again....i dont know why it is required. These...
  6. T

    Help me with a project that uses Siemens gsm/gprs module

    i m confuse where to post this question.....well i m trying to do a project in which i continuously sending data to the internet using gprs after particular time interval say 1 or 2 minute. And whenever message or ring comes it should stop/close the internet connection and handle these msg/ring...

Part and Inventory Search

Back
Top