Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am aware of the "Chaos Law", and I also heard that the seniority of an engineer is proportional to the degree of chaos of his/her bench.:LOL:
But I don't have big bench at home, just a regular sized desk. Hosting all these stuff on it and keeping them safe is a big challenge to me, so I'm...
Sorry if it's off the topic. I'm playing with several evaluation kits and devices, including an expensive FPGA board. I have to make room for these boards, a small network switch, a small power supply, a notebook, a computer monitor of course, and sometime a soldering station. I need to manage...
Sorry if this is the not the right place for this post.
---------------------
I need to put a BGA and a QFN onto my board which has several GND planes under the chips. I tried to solder the QFN with a hot air gun but had no luck as the soldering paste didn't melt at all. I quoted online and all...
I want to use a frame to support and strengthen my board. Is aluminum alloy a good choice considering the price, weight and strength? Where can I customize for 1 piece?
I need to mount a PCB on a remote control vehicle. The board is a little bit big (13inchx7inch), so I want to provide enough support to prevent it from bending. What came to my mind is using some kind of aluminum frames that can be fastened to the PCB with bolts. What are the good/cheap ways to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.