Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is good stuff. It's much appreciated. Iv got some work to do. I will start out small with some testing and see how it goes.
Could I get sensors robust enough to withstand vibration from travelling along and possible splash from the chemical of the sprayer?
This sounds really cool. Sounds like it could work. However I can't stress how amateur I am when it come to things like this but a bit of practice will do no harm.
Any chance of a wiring schematic?
Just a couple of questions if that's OK.
Would a 12v battery from an atv power all this?
Also...
Thanks guys, this is great. Very informative. I just assumed that ultrasonic sensors would bounce off any object. See attached the 1st image of the weed rush. This is the main weed I would be aiming to tackle. As you can see it's very straight, pointy and stemy and sits up well past the grass...
Thanks for your reply Brad,
Isn't that the idea of a ultrasonic sensor?
Going high-tech sounds expensive.
Is the camera option expensive? Could possibly play about with different options but I just need a general starting point and how to go about it.
Evening all. I am new to this and am rubbish at electronics. Hopefully I can get some good advice here.
I was going to modify a atv sprayer boom so that I could fit some ultrasonic sensors beside each nozzle and wire it to a solenoid valve which will be plumbed to the pipework of the sprayer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
