Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm using an antenna that works in the range from 1 GHz to 3 GHz. I want to match impedances between a cable from the transmitter and the input amplifier and from the output amplifier and the cable to the receiver to get the maximum power and the lossless.
I found that there are some techniques...
Hi,
I read that:
To use 2 layer instead of 4 layers, it's better to place ground planes in both layers to minimize the EMI problems. Is it not correct?
Decoupling capacitors should be attached to each active components and a larger bulk decoupling capacitor for each voltage distributed on...
Hi,
I'm designing a PCB really simple with connectors, resistances and transistors. There are some rules that should be followed to pass the EMC test.
1. Using only 2 layer PCB is better to use ground planes in both sides.
2. Place decoupling capacitor between gnd and power in each active...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
