Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi everyone
I'm trying to send GPS data through GSM my problem is that i want to send latitude and longitude and North or south and east or west only and i have to name them in the message this is my code and i dont know what is the problem I'm using a psoc microcontroller so if anyone can help...
hi everyone
i have a system that consists of a GSM and a GPS module interconnected together using PSOC as a security module for cars. I use the built in switch to operate the system. if i open the first switch, the GSM module sends me a message containing GPS data. Now, I need to change the...
actually both the gsm and gps use UART protocols. my problem is that when i save the data from gps into an array and try to send them using GSM all i get are some weird symbols. the baud rate of the GSM is 19200 and that of the gps is 9600
Thanks again for your reply Anitha
thanks for your concern i am using UART i need to save the occurrence of data after the beginning of a command which is basically $GPGAA and send it to a mobile by a gsm module
Hi everybody
I am new to using PSoC and i am seeking help to connect a GSM module and send messages through UART tx of a CY8C29666-24PVXI PSoC using AT commands
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.