Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how can i see full name of TR in hspice output list file?
if i run transient simulation in hspice and i put command '.op'
then normally i can see DC operation point in hspice output file.
but when my hierarchy structure is complex or subckt name is long, i can not see exact TR name.
for...
i try to pole/zero analysis using .PZ statement
but if i make these input file, hspice shows me this kind of messages
input file :
c rc 0 10p
r vin rc 10k
vvin vin 0 dc = 1 ac = 1
.pz v(rc) vin
.ac dec 100 1 1G
lis file :
Source for Pole/Zero analysis vin cannot be found, analysis...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
