Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
The coils, coil segments, voltage/current paths are field sources, it forces current or voltage through the circuit you designed. After simulation you will have the results in form of field or current density, but I don't know how to integrate it to get total current or voltage in a given...
Hi, I don't know why, but when I needed simulate a long waveguide, due to mesh size, I simulated a fixed length (i.e 2m) and used CST Design Studio to couple it in series the same structure all desired length and calculate the equivalent S-parameters.
Hello sztr,
Within Modify Waveguide Port (just double click the port1 at Ports/Navigation Tree), you can check the box Polarization angle at bottom right and set the desired polarization.
Regards.
Dear All,
I need to simulate a transformer using CST EMS to eddy-current and thermal loss estimation, quite similar to the following application:
https://www.cst.com/Applications/Article/Coupled-EM-Thermal-Modeling-Of-Power-Chokes
I designed the transformer coil with copper wire and set...
Hi,
As you increase the dielectric constant, the modes number increase too. It means there are more than 1 mode propagating in your resonator. So, you have to increase the number of modes in that simulation, what can be done within port1 properties (Number of modes).
Regarding the mode...
Dears,
I am simulating a kind of coaxial cable at CST MWS using TD and need to know losses in metalic walls and dielectric in all simulated band. I can see these losses in 1D Results/Power/Excitation but it is for just 1 frequency, that frequency specified to H monitors. Does someone know how to...
Hi Mona7150,
You will define the modes number, e.g how many modes are simulated, but what will define the propagating mode (TE, TM or TEM) will be your geometric structure. If your structure is a hollow waveguide, you will not see TEM modes, because the boundary conditions do not allow...
Hii everyone,
When I click 3Dpolygon from Curves menu, a window offer a option to load xyz data from .txt file. It's very good!!! But I have hundreds of files to load and it's borring and wasted time to load one by one...
So, I'm trying to program a macro for CST import several .txt files with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
