Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
www.cs.umbc.edu/~cpatel2/links/418/.../chap7_lect08_atpg.pdf
This could help u in understanding what is ATPG (as introduction).
---------- Post added at 09:26 ---------- Previous post was at 09:26 ----------
www.cs.umbc.edu/~cpatel2/links/418/.../chap7_lect08_atpg.pdf
This could help u in...
Hi All,
Can any one explain me what is the difference between Noise Density(ND) & Noise Floor.
According to definitions
1# "Noise density is defined as the average noise power in 1 Hz bin",
that means wide band noise when spread across the Oscilloscope Bandwidth, each 1Hz bin will have a...
Thanks Mr.bapodradhairyab
Can you elaborate on "add DSP features"
Is the Kit customizable to our needs
Also tell me whether can i do FFT algorithms with in the FPGA
(I'm not familiar, since DSP will be a form of software algorithms, which means that there should be some sort of processor to...
Further in more simple terms
Passive Load is Load comprising of Passive Components
Active Load is the Load comprising of Active Components
In Test Boards its better to use Active Loads, If you are concerned about Temperature Variations during characterisation
Regards
Vamsi
Hi Ppl
My Name is Vamsi, I want to buy an FPGA Evaluation Kit
Could any one guide me which is best for educational treatment
I need to use
1> Analog Converters on board along with
2> Digital Gates and also need some
3> DSP capabilities.
What could be the cost that fits to above...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
