Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone.
I am using Cadence IC5 to simulate a 2 stage opamp noise.
What I want is to find the corner frequency where 1/f noise equals thermal noise.
The problem is that from "direct plot->main from->noise" I can see the 10dB/decade roll till 1kHz, then the power begins to keep decreasing...
Hi all,
The amplifier input impedance is giving me a headache even I looked for answer from these two posts:
https://www.edaboard.com/threads/29869/
https://www.edaboard.com/threads/230983/.
First of all the situation is for receiver end not transmitter. My question begins with the unfinished...
Thanks for your reply.
But when we talk about impadance matching for LNA, it is Zl=Zi*. Is it happen to be that power matching is the same situation as noise matching?
Hi all,
I am wondering why we do impedance matching for LNA. Because in most sensor circuits where opamps are used it is the input voltage to amplifiers are maximized.
From this post https://www.edaboard.com/threads/67820/ I only understand that when maximum power transfered to system the...
Is there a clear definition difference between these two amplifiers? I know input impedance of INA is large and usually do not need matching but why can't it be low noise? Does impedance matching helping LNA achieve low noise effect? Can LNA be used for low frequency (below 100Hz) high...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
