Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by tejaswiau09

  1. T

    beam width calculation

    practically how to calculate beam width of a patch antenna array when gain and directivity is known?
  2. T

    Low pass filter using CST simulation

    port should be connected to all the three filter strip, dielectric and ground metal layer
  3. T

    Relationship of microstrip width and length

    if width is greater than length , still it acts as a transmission line. a patch antenna design is one example, for a rectangular patch width>length
  4. T

    feed design for 2x2 patch array antenna

    yes wilkinson power splitter, got your point 100 ohm seems to be virtual tq, without bending edges will ther be any degradation in the signal .
  5. T

    feed design for 2x2 patch array antenna

    tq pragash. can a 100 ohm line splitted from 50ohm can also be of any length. i am matching 50ohm 100ohm 70.7(l/4)ohm 50ohm
  6. T

    feed design for 2x2 patch array antenna

    in inset feed after matching patch antenna impedance is matched to 50Ω stripline. does it have any significance on the length of 50Ω strip line or it can be of any length i am new to design and planning to use λ/4 transformers for splitting feed(two T junction splitters)
See more

Part and Inventory Search

Back
Top