Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you both for your help. I just figured it out.
I looked at the a part in the library and realized that the rectangular geometry bounding the component was not actually defined in the footprint. I had a room defined improperly causing a conflict. Apparently this causes the cross-hatched...
Thank you for your response. The components in the screenshot are all from the standard libraries. None were user created.
The bottom layer component I highlighted is an 0603 resistor. Here is the footprint information:
- Name: RES0603N
- Library: IPC-7352 Chip_Resistor_N.PcbLib...
Hi,
I am running Altium Designer Summer 09 and have been pulling my hair out trying to figure out how to display the cross-hatched area displaying the component boundary on the same layer as the component itself. I'm not sure how well that describes my question, so attached is an image of the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
