Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI,
I am a new user of Eagle. I was trying to design a PCB like the figure. I can not get rid of these red shaded regions( in between MSOP16 pins). At the beginning I thought this is due to ground place which I put initially using rectangle. I took off the entire GND plane from first layer but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.