Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi I got a bit further
The CST design kit is old and cannot be imported in ADS 2015. Any idea of a workaround?
I f anyone can provide a compatibility table of CST design kits with the ADS versions i would greatly appreciate it.
Thank you
Syl
Hi
The polar function in matlab is in radians so you need to get you increment of 2 deg in radians. This can be calculated as follows (2*pi/360)=0.0174532925199433/degree. For 2 degrees you take 0.0174532925199433*2 steps. Code is simple as per below:
theta = 0:0.0174532925199433*2:2*pi;
Gain =...
Hello Everyone,
I designed a HF rectifier circuit in cst MW and i want to co-simulate this in ADS. Unfortunately i got stuck in the ADS setup. Does anyone have a document that would indicate how to do this step by step?
Thank you
For your reference i found this **broken link removed**
Best...
Hi,
I theory the components i.e. chips are to a certain degree hygrophile get a certain ammount of water from the enviroment-i.e. air. If temps are below freezing could form crystals and do some mechanical damage to more sensitive components when water crystalises-capacitors are rated -40C most...
Hi Lads,
I created a macor to generate an antenna with a port and all but it doesnt update automatically when i chage the parameters. Some parts repeat themselves and i replace them with functions. Unfortunately the macro runs once but when i update it doesnt recognise the functions anymore and...
Hi
For your application select a discrete port and add it to the I/O-pick edges etc. add discrete port and select type Voltage. Voltage monitor follows a path similar to the discrete port but slightly different from A to B i.e. middle of your inputs/outputs draw a line named VM or someting and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.