Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to how to design Fero-Resonance Resistor value in open delta PT. I want an output of 0-30Volts specs of PT is:
11000/V3 : 110V/3 100 VA 3P( open delta core of transformer with these specs)
Hello everyone
I have an energy meter for HT(11kv) system for installation with cts and pts.. Can anybody tell me exact connection scheme.. Picture is attached
Hello Everyone:
I need an alternator of 80 kva, I have a 2 companies from where i can buy, Please let me know basic parameters for comparing alternators. And (Meccelte or Stamford) which company is better for an alternator and why that company is better.
Bro (GRASSLIN TAXXO or HANYOUNG LT1) these are the switching timers i think, but i just need to note the running time of my generator, don't need to switch it after specific time.
- - - Updated - - -
Bro (GRASSLIN TAXXO or HANYOUNG LT1) these are the switching timers i think, but i just need...
Thanx Umair: But the problem with LDR is that in daylight it will be sensing the sun light which means counter will not work according to my requirement bcz i just want to count the generator's running time. Can you Guide me to do this using a PIC or Micro-Controller along with ADC etc
Thanx...
Hello :
I need to make a counter which start the time when a single phase supply is connected to it, Actually i want to connect it across my generator so that i may be able to check how long my generator has been running, means i want to keep the record of my generator's running time. i prefer...
yes eiphan i have this idea, but i don't have sufficient data related to this.....can you further help me.. i have the block diagram related to my project idea here it is
---------- Post added at 17:09 ---------- Previous post was at 17:07 ----------
yes eiphan i have this idea, but i don't...
I am doing my project on the topic (Single phase to three phase converter for driving three phase induction motor.)
Can Any one upload data or link related to
Single phase to three phase converter for driving three phase induction motor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.