Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am using the ADE7757 IC for Enrgy Meter. I refer the Schematics that are in the DataSheet.But i not geeting the 5V as the Power Supply Circuit.
I don't that much of knowledge about basic electronics.
My I/P to the 7805 is around 3V and the O/P is 1.68V.
Please Help
Thank You
Can I used CT insted of 350 micro Ohm Resistor to measuring the current
Hello,
I am using ADE7757 Energy Measuring IC in that They are using the 350 micro Ohm Shunt Resistor. SO can i USE the CT instead of 350 micro Ohm?
Thank You
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.