Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Board design Process
HI Frends
I wanna know the design guide to start for any new project.
As I dont know how to make a design specifications before starting a project.
Regards
Suresh.B
decoupling capacitor
Dear Friends
Can any one help me how to calculate decoupling capacitor values and what is the main purpose of the these .
and also help me
if any notes or material is available how to check time varience for interfacing two devices.
Regards
Suresh
Re: phy to phy interface
Hi
AC coupling is working well and good if i check the two ports of IP175C and individually both the ports of both the devices are ok they are respopnding but when i tried to interface both these with some termination resistor circuit in parallel between the pair of...
rgmii back to back
its not like that actually if we want to interface a phy with a mac means we will use a transformer in between in the same to interface PHY to PHY i got one refrence in that refrence they had mentioned to add a capacitor between each signal of 10 Uf.
and i had done that but...
phy to phy connection
Hi
I am interfacing PHY to PHY (IC175c and BCM5482) using an capacitor of 10uF ,and the difficulty what iam facing nowis it s not showing any linkup status.
So i wanna know how can a phy to phy interface can be done.please suggest any other means of interface and also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
