Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Now I'm doing 6 layer board. Top and bottom used for componet placement . Remaining layers 2 and 5 for ground and power. 3 and 4 for routing. this top layer SMT component's pad should accept only top trace instead it is accepting all layer trace without via.
Regards,
R.Suresh.
Hi
Top side SMT component should accept only top trace but instead it is accepting both the top aswell as bottom trace without via.Here I'm using PAD Power PCB version -3.0.
SureshR.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.