Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi all,
when I use artisan memory.
I don't know how to make a good decision to set memory EMA after I read the data sheet.
:roll:
I don't understand it is not good when EMA is smaller than default value.
If I have a critical timing issue , may I use EMA= 000 for STA timing.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
