Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
The main problem is that device works from battery. So need design a circuit and avoid excessive supply current. Of course I disable LFEN, but what happen on PIN? I don't know. Maybe better connect pins to ground or leave floating input. If it will be a common gpio CMOS input like on...
I designed TPMS sensor on freescale FXTH87 and I don't want to use LF receiver, so I have to configure LF pins to avoid a floating input. What I have to do? leave pin not connected or connect to Vss, or something else?
from datasheet:
Each LF[A:B] pin will always have an impedance of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.