Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by sumansamui

  1. S

    why does not thermal runaway occur in fet?

    please explain this...........
  2. S

    Amplification of RF signals is itself a very difficult task........explain please

    why this is so.please explain....
  3. S

    development board/kit for embedded system project

    i am a novice in embedded system project .i have a little bit of experience with embedded system project.which development kit will be good for me for initialy?
  4. S

    what is the difference embedded system and soc?

    can we say all soc as embedded system......but all embedded systems are not soc
  5. S

    what is the difference embedded system and soc?

    .................................. ---------- Post added at 17:32 ---------- Previous post was at 17:32 ---------- please discuss
  6. S

    mosfet small signal analysis

    why Csb is not considered for medium frequency analysis in mosfet?
  7. S

    mosfet noise calculation

    in gate noise calculation,how can we replace distributed gate resistance Rg by a lumped resistance equal to Rg/3???
  8. S

    How to reduce the size of diode and place it in an IC?

    Re: Ic design and layout how to design superdiode?
  9. S

    how copper wire interconnect delay depens on its width and length?

    i need a mathematical and valid delay model.is elmoore's delay model applicable for recent technology trends?
  10. S

    How Can I Build a Digital Clock Manager In VHDL

    what are those different modules?
  11. S

    what is the difference between optics and photonics?

    when i should use the optics and when photonics.plz clarify my doubts
  12. S

    How to reduce the size of diode and place it in an IC?

    Re: Ic design and layout AS FAR AS I KNOW MOS DIODES ARE USED IN IC.i.e,the nmos or pmos with gate and drain shorted.
  13. S

    how do schrodinger equation be relevant in the design of CRT?

    thanks mate,would u please clarify your answer.it's too specific.i need some explanation.
  14. S

    how do schrodinger equation be relevant in the design of CRT?

    Plz clear my doubts..............
  15. S

    what actually do we mean by any particular technology?such as 90 nm,180 nm or 16 nm .

    ok....thanks a lot
See more

Part and Inventory Search

Back
Top