Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear PlanarMetamaterials, Yeah, Its right, I am getting the expected results.
My few concerned are given one by one :
1. If Field goes outward or inward from Signal to ground. Can we say both are the same thing?
2. The S11 parameter is different that one can expect for a CPW line. The...
iInP and nInPh are defined as per their property please check their moblilities values. Yeah, I m not sure about boundary defined. Actually, I have an example from HFSS library about CPW in which they assign the boundary in the same manner and getting expected results.
Dear FvM,
I am grateful to your for your prompt reply.
The expected results are already given in previous post. The objective is to have low reflection (s11) at 40Ghz. I just want a second opinion from the professional like you to validate the authenticity of my results.
Therefore, Please have...
Dear Sir,
Thanks for the reply.
My structure is a pin photodiode whose dimension and expected field output is given below. The field is calculated with other software where width of arrow is proportional to field. The field is expected to be higher in central i-region (i-InP) and should be...
Hi,
I am simulating an ungrounded CPW structure through HFSS. I used all the references available on edabaord website and followed HFSS tutorial on CPW but still far from getting good results.
The field profile and s11 curve is shown below. The field is stronger in the intended i-region but its...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
