Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by subspace

  1. subspace

    [SOLVED] Communication Problem:: RS-485 (MASTER) and RS-485(SLAVES)

    Re: Communication Problem:: RS-485 (MASTER) and RS-485(SLAVE the slave obtains its gnd and power off the Master PCB board. thus the power and the ground are the same for both MASTER and Slave. twisted shield pair cable will be used for A and B lines. by the way, the track length for line A...
  2. subspace

    [SOLVED] Communication Problem:: RS-485 (MASTER) and RS-485(SLAVES)

    Re: Communication Problem:: RS-485 (MASTER) and RS-485(SLAVE Thank you guys for your help. By the way, I think I forgot to mention the following parameters of my system: 1. Baud rate = 38,400 bits/sec 2. Max. Number of allowable slaves is 4. 3. Connection of about 1000 meter cable (maybe...
  3. subspace

    [SOLVED] Communication Problem:: RS-485 (MASTER) and RS-485(SLAVES)

    Hi, I am working on a project of interfacing PIC uP (MASTER) to Multiple PIC uP (SLAVES) through the use of half-duplex RS-485 chips. I am using daisy chain topology for my network. Hardware configurations: ----------------------------- all of the RS-485 chips are connected as follow to the...
  4. subspace

    What's the purpose of opto coupler MCT2E?

    Re: Opto coupler ... Most of the time opto couplers are used to protect communication lines. for example, you can use opto couplers to protect your Tx, and Rx lines between your RS232 and PC, from power surge that would be harmful to your PC and RS232 chip. you must keep in mind that if you...
  5. subspace

    3d image of a pcb from pads

    1. export DXF file format 2. Use one of the following softwares: A. AutoCad B. Solid Works C. 3DsMAX In general all 3d softwares out there use a DXF File format. the question is which 3D software is easy and fast to use
  6. subspace

    Question about developing a Gerber Viewer in C++

    Re: Gerber Viewer I can not find a very good and free Gerber viewer online. can any one recommend a free Gerber viewer. I look forward to try Minumula's gerber.
  7. subspace

    Which PCB tool to choose?

    I agree pads is a very good choice for: 1. a budget of 4k - 6k 2. for layout Engineer only 3. learning curve is less than of Orcad
  8. subspace

    How to start with pcb layout?

    you should start with the basics and fundamentals behind PCB and Layout Design

Part and Inventory Search

Back
Top