Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You need to install XP first, then Linux. Otherwise Microsoft destroys the MBR & bootloader. Ubuntu should have OpenOffice which will open MS Office files. As for PDF, the default printer in Ubuntu is the PDF generator. Ubuntu comes with a pdf reader but get the real thing from Adobe. It's...
Re: CNC Machine
Have a look at https://linuxcnc.org/
EMC2 motion control running under RealTime Linux.
A lot of your work has been done and alll you have to do is ask questions.
The folks are glad to help get started and fine tune systems. Many of them use
servos (I'm still in steppers) and...
Most steppers will resonate at some frequency and stall as you described.
Do you have a different motor you could substitute easily?
Some brands have better/different performance in that area.
I found this out when building a CNC router. My "Y" axis would stall above ~24 IPM
with my original...
Check for a firmware update for the drive. That usually fixes problems.
Did the software return any errors?
Does the software have a "Verify" mode? If so, turn it on.
HTH, Emory
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
