Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sunny thanks for your very informative response...I do believe its oscillating on both motors but it's fine with the faulhaber...I don't have a scope so...you say the 1R I assume your speaking to the 1M resistor...just a bit more info those 1M resistors are actually 100k with a 4.7 ceramic...
Vbase thanks I'll try that...I know there is a 4.7 across a 100k resistor it's not a 1M...audioguru thanks for suggestion but it's in a very small board already...I kinda inherited this...it's been working nicely with the faulhaber motor as I've said...it just started doing this with a new servo...
Hello all newbie here...just want to say I really enjoy reading these posts and I have learned a great deal...however I do have a question but don't have a lot of info...
OK I have a analog LM675 op-amp circuit that is used to drive a DC motor positional with a potentiometer...all is well with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
