Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In PCAD, it was possible to place a sheet connector on a net that would show directly on the schematic the zone and page where the net travels, such that when looking at a printout of the schematic, you would know exactly where to find that net on other pages.
Does anyone know if this is...
After printing my schematic for the first time, I realized the text and port size are too small to be read.
I discovered how to change the system font size, but I can't find the setting that allows the port symbol to auto size to fit the selected font.
Any suggestions?
I have imported a fairly complex board from PCAD into Altium 10.
Some of the original components were created in a way that allowed the silkscreen to touch. I am now receiving a ton of errors.
I have tried creating a design rule to allow a component clearance of 0.0 mils along with turning...
I am relatively new to Altium and have been plodding right along, but I am stuck...
Is there a way to set a seperate clearance rule for "pad to pad?" I found the electrical clearance rule, but I wanted to set a seperate clearance for "pad to pad" and/or "via to pad."
Thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
