Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Magic Developer TimEdwards indicated that it was changed to show micron and not lamda.
For scalableCMOS , he suggested some script modification.
see the 'magic mailing list' for suggestions.
In the measurement readings,
8V - 0,70V
10V - 1,95V
12V - 2,83V
14V - 3,20V
16V - 3,80V
the meter itself shows a nonlinearity.
for equal increment in scale reading it doesnt show
a linear relationship with voltage you applied.
whatever is the circuit proposed/added the nonlinearity
cannot be...
you gave certain voltage readings as:
8V - 0,70V
10V - 1,95V
12V - 2,83V...
what does it mean ?
you may have to explain more on the damaged meter and
how did you took the readings.
whether the meter is working or the component
connected to it is damaged.
a simple handdrawn circuit of the...
In single supply the same supply supplies current for both half of circuit.
In dual supply , each supply supply current only for that part of the waveform.
what contoller compiler are you using?
1)your for() loop execute only once.
what is the rand() output range ?
in standard c it may be anything from 0 to 32k.
dividing by 5 , you may get a max of 6000 approx.
equivalent remainder of 2000(approx) seconds in your timedelay routine.
and you are...
In addition to proper audio grounding as suggested ,
add a electrolytic filter cap at the input pin of lm317 at
the input and ground pins of IC where DC is applied
in your circuit.
Re: Putty error (SSH) - DISPLAY NOT DEFINED
try display field as -127.0.0.1:0
if not working it can be due to multiple monitor issue or some other
display driver mismatch in xming .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.