Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
This time I am stuck with the PCB for PIC24FJ64GA004.
I have to build a basic board (Crystal oscillator,MCLR circuit, capacitors as per datasheet, and Programming pins)
I am leaving few pins to a connector so that i can connect PICKIT3 and program the controller.
My doubt is regarding...
Hi all,
I have found the solution.
Actually I was connecting wrong wires to the motor coils and understood my mistake.
But Heat problem is still present. It heats upto a particular temperature only. Since I am interfacing it for the first time, I am a little worried about the temperature...
Hi,
I learning to interfacing a PM55L-048-HP69 Stepper Motor to 8051 (unipolar)
I am using L298N as driver module bought here in local market.
.
I have connected the coils to pin (2,3) & (13,14). Logic Voltage of 5V to pin 9. The module has the remaining circuitry to operate.
I have connected...
Hi all!
I am doing an lcd project using the shift register.
To start with the shift register i had written a small code with the circuit diagram.
But i am not getting the output i need. Kindly help
My code:
=========================
#include<p24fj64ga002.h>
#define output PORTBbits.RB15...
I have downloaded the kit manual. Can i do the connections as shown it it???
I did not do it as it has many other things like the usb interface, etc. I dont need them. I just want to use the PIC microcontroller.
Hi all!!
I am seraching the isis proteus model for " 16bit 28pin evaluation board ". with PIC24fj64ga002 microcontroller
Kindly help me find it. More information on this board is :
**broken link removed**
Hi all, I have just started programming 8051 .
I want to control a geared dc motor ( 12 V)
I am using the l298 driver.
I could connect the In1, In2, EA to controller and OUT1 and OUT2 to the motor. and connected SenseA to GND
I want to vary the current of the load(motor).
Please help me to...
Hi,
I have designed a MCU using proteus.
To port 1, I have connected ULN2003 and its outputs to the column of a 5* 7 dot matrix display.
to port 2 also a uln2003 and its outputs to the rows of the display.
So of port 1 --5 bits are used and of port 2--- 7 bits are used.
Now I dont know of how...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
