Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry I don't know much about motors
High Slew rate cause over or under shoots - The PCB trace or wire or even ICs pin is combination of L, C and R. The values are so small that when signal tr and tf is small they do not affect the signal. Hence signal slews smoothly. When the slew rate is...
LEDs are made of many combinations for various colors. Lesser junctions lesser breakdowns. LEDs can be GaAs, GaAsP, InP, GaSb, GaInP, SiGe, InGaN, GaN, GaP and so on... Lots of LEDs are there for different color, coherence, luminance and Vf
For low breakdown choose p-n junctions i.e. GaAs, or...
Modelsim is more of simulation and analysis tool not a project development tool. Xilinx ISE is a project development tool. However the inbuilt simulator in xilinx is not as professional as modelsim. modelsim has lot of features, tools to completely analyze your simulation. So if u r thinking of...
I think by generators you mean Function Generator?
Slew is not always bad. Practically there can not be any system without slew. low Slew gives a advantage of very less over/under shoots. But slew is very important when working with high speed digital designs like FPGAs and processors. If the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
