Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Unaz,
To fabricate patch antenna using LPKF prototype machine,
1. Import the individual dxf files of top layer and bottom layer of patch antenna.
2. After assigning top and bottom layers,
3. Assign the rub out areas.
In this way you can easily make the patch antennas using LPKF machine.
I am trying to redesign the log periodic antenna given in feko examples. After simulation without electrical symmetry i am getting the output, but with electrical symmetry i am unable to simulate, I am attaching my file. If possible please find the solution for this problem.
I understood your problem...
After drawing the second bow tie using draw line command it takes the same level of previous bow tie design....
In this situation just select the second bowtie each and every poly lines and change the substrate height in every polyline.
At the end of all changes...
Without adding proper solution frequency in analysis it give that error. By defining the solution frequency it starts meshing and analyze your model. So go to analysis in project manager in analysis add the solution frequency of interest.
You can do these to reduce the simulation time...
a) Minimum no of passes
b) Uncheck the save fields
c) In Frequency sweep step size should not be very small
d) Frequency sweep range to be kept as required range
I observed from your simulation file that everything is fine with small changes
1. Remove the so many setup files give the one set up with frequency sweep from 3 to 11 GHz.
2. Now take the gain in dB from farfield radiation pattern at particular frequency with desired theta and Phi values..
Re: How to convert !d to 3d object in hfss
You can also try to change the 2D objects in to 3d by assigning the thickness of the material....
Modeler>surface> thicken sheet
give the thickness or increment value in desired direction....
then it is converted as 3D object and assign the...
I want to observe the time-domain performance of UWB antenna in CST MW studio. Can anyone help me how to get fifth order Gaussian pulse as input to the my UWB antenna.
Dear SLK001,
I have another question for this. What are the parameters we have to define for the oil?
Only Dielectric const and conductivity enough for oil or any other parameters required
Hi sandeepkiranv,
Importance of sma connector in the antenna simulation is less. If you are interesting in observing the fields at the sma connector only you need the sma connector in simulation. For waveport in cpw case just you take width as just more than three times of feed line width and...
Dear rizoeda,
This save preview images option will help us to show the our model image as a image when you open the old files. Try to open by saving the with enabling and without enabling the two files. When you try to open the one you enabled will show the preview of your model other one...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
