Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by spring1860

  1. spring1860

    What's the difference between SNR and CNR?

    difference between snr and cnr what is CNR?
  2. spring1860

    [ 20 points ] Source of Current Material

    hi may be this slide will help you. regards.
  3. spring1860

    THD reducing by using oversampling - is it possible?

    Re: THD I don't think so
  4. spring1860

    Razavi or Gray 's analog book for beginner

    i agree razavi first and then gray
  5. spring1860

    tail transistor considerations

    hi about the tail transistor. how to consider it , such as L , gm, or some else . please give your ideas thanks.
  6. spring1860

    offset of fully differential amplifier

    hi r1=r3,r2=r4. RL and CL is the load of your circuit. CMFB must work. do OP analysis and the difference between VON and VOP ( VON - VOP)is the offset of total ckt. then , r1/(r1+r2)*(VON-VOP) will be the offset of the amp. B.R.
  7. spring1860

    MOSFET mismatch in the differential pairs

    mosfet mismatch hi maybe this doc helped you BR
  8. spring1860

    offset of fully differential amplifier

    hi see the following connection, and the out will be the offset hope it helped to you.
  9. spring1860

    how to do the stb analysis for opamp in cadence virtuso

    stb cadence is there a 'loop gain' selection,, haven't you see it ??
  10. spring1860

    measurementof SFDR and SNR of ADC in cadence

    hi matlab is good for post process
  11. spring1860

    RHHP and complex pole

    would u plz explain why ?
  12. spring1860

    gate capacitance value of a CMOS transistor ?

    yes, i know your mean, thank you very.
  13. spring1860

    How to simulate pop noise in CADENCE?

    hi , i cann't find this paper ,would please upload it . thanks.
  14. spring1860

    slow CMFB clipping output

    Analysis of Switched-Capacitor Common-Mode Feedback Circuit Ojas Choksi, Member, IEEE, and L. Richard Carley, Fellow, IEEE it says "CM loop should be comparable to that of the differential loop to avoid output signal distortion resulting from clipping due to slow settling of the output CM...
  15. spring1860

    Running input.scs file in Cadence

    what is input.scs file
See more

Part and Inventory Search

Back
Top