Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have imported a model from IRF. it is a MOSFET. I used it in my schematic. Now I want to do some modifications to change the name attributes from 1 2 3 to the actual Drain Gate Source. How should I do that so that can make sure I haven't corrupted the file completely. The reason i am...
expecting keyword stimulus, saw 0
Hi,
Thanks for getting back to me.
I actually solved the problem in a stupid way. Apparently I just needed to change the GND name to "0" (zero). before that I was using GND_FIELD SIGNAL ground.
FYI, here is the schematic:
---------------------------------...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
