Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Oh, that helps quite a bit, thank you. :)
So Rsense should be calculated as 100mV/I, correct? This seems to match up with the schematic such as on this page:
Nixie HV Switching PSU
I.e. using 0.1Ohm resistor to limit current to 1A, 0.05 for 2A, and 0.025 for 4A.... But it appears the limit is...
Hello all,
I'm building a 7v to 180v supply (for nixies) using a max1771 IC. At 180v, the least amount of current I will draw is 2mA and the most I will draw is 94mA. I've read through the datasheet a few times, but I had a few questions as I am quite a novice when it comes to switching power...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
