Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
" Say suppose we got particular error message "all the bits of signal dout are not uses".
As a designer we know it is expected and can be waived off, then how can I write waiver for this error message."
Hi ,
In log file there will be a rule name ahead of this line "all the bits of signal...
Hi newebu,
Setup violation means due to greater delay in datapath,data cannot get set on the input of second flip flop when clk arrives (posedge or negedge) on its clk terminal.Hence for its removal you need to decrease the data path delay or inrease the clock path delay.So if delay of 2...
Hi Raghavendra,
U can do it by following command :
waive -msg "all the bits of signal dout are not uses"
or if u want a particular rule to waive
write
waive -rule "RULE-NAME".
Regards,
Sohil
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.