Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you Jonh blue,
Link is good and I will study hardware and soft descripted on link. In this link is used custom made lcd display. I will use normal 3 1/2 or 4 character display.
So I am still looking schematic for CCS kit from first thread.
Does anyone have schematic and sample programs for PIC16F1937 Development Kit designed by ccs.
CCS, Inc. - PIC16F1937 Development Kit
I would like to strart one projects with lcd withoud driver and this will help me to start.
Thank you
Did someone use this panel meter. I would like to buy but I don`t know who is
manufacturer.
Please help to find manufacturer or some distributor.
Regards
Re: analog design U-I
All this IC have some resistance in ON positions. From few to 250 ohm.
If I use resistor 124 ohm for current measure and switch R ON is 10 ohm.
I think this will couse errors in my measurments. Also I don´t know what will be with resistance temperature drift. I use 25ppm...
Re: analog design U-I
I need analog design for block marked red in attachment.
Univesal input for 4..20mA and 0..10V to A/D conversions controled by PIC
Regards
Hi
I need help to design U (0..10V) and I (4..20mA) input for A/D convertor with analog switches controled by microcontroler.
IDea please
regards Bojan
1wire search rom
HI
I was successful to read 64 bit ROM adress from my 18S20 and manualy write it to program.
Program detect the sensor, but does`t show correct temperature. LCD alveys show
3,39 C even to worm sensor with fingers.
Any idea where is problem?
Regards Bojan
DIN case manufacture?
I am trying to find low cost DIN case, like this in the picture (made by Bernic).
Please suggest producer. (Italtronic , bopla, okw, phoenix are too expencive).
Bojan
www. search-roms .com
Finaly I made, very useful, TNX
Your CODE is working in my test board. But now I have new problems.
I do not have debagger circuit for testing code step by step.
Which variable present temperature ?
Bojan
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.