Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: help with shift registers
You could store the binary information in an boolean array. Then write a loop to go through the array and write out the information.
start by pulling the RCLK pin low, then:
Pull the SRCLK pin low -> Toggle the SER pin depending on if you want that particular...
This should be easy for someone. I have what I believe to be a 2W resistor that was potentially damaged, so I can't measure it.
The color bands are -> Black, Red, Silver with a gold Tolerance band. According to a chart I found, this would be 02 * .01 = .02 Ohms
Is that correct? Thank you!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
