Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For example Input B is an audio of a radio. And output is Signal B, which is amplified. When Input A, which is Signal from a Microphone, is active, then the Radio signal should be cut off and output should only be Signal A.
Hi,
I am looking for a 2 input mixing audio amplifier.
When "input A" has a signal, Amplifier should not amplify Signal B.
The amplifier is used in car and should be low noise.
Regtards
Re: Electronic Noise in BUS
Would you please let me know the noise band in the transportation bus vehicle?
We used DC-DC converter, but it still can not protect the electronic boards from the noise.
The timekeeper loose data because of negative overshoot. The board make error because of noise...
Data loss in timekeeper
Hi,
We use DS1302 timekeeper in an electronic device in bus.
We use a 3.3 V battery to provide voltage for timekeeper.
But many times, the data of timekeeper is reset.
Can anyone help me to avoid this
Electronic Noise in BUS
Hi,
Who has experience in electronic noise in the bus?
We designed an electronic device in the bus, but electronic noise in the DC voltage, in the bus has bad effect on our devices.
Regards
we have 400,000,000 record of 25 bytes, each record also have 7 fields of data. please let me know if Postgresql can answer our needs or we should go to Oracle?
Re: RFID question
You can use different reader and antenna for moving object in building.
Also some reader can support up to 4 antenna which you can prevent more cost.
But as you said the UHF reader price is high. You can also use low range wireless transceiver, which is very cheap.
Hi,
I want to control a parking gate (24 volt relay) with a pc.The distance between pc and barrier gate is 30 meter. At first please let me know should I use microcontroller or RS-232 can control the relay itself. then please send me the needed schematic and source code.
regards
I need complete schematic and code for a microcontroller which has a link with a pc via RS-232, and pc send a command for microcontroller to control 2 pcs of 24 volt relay.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.