Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the 2 DC motor will take all this voltage even to overcome initial condition
so i think the Voltage remaining is (2.5 -4v ) so the Microcontroller is working only for 3 mn otherwise the Microcontroller is burning quickly and never working
i believe the problem is with ic L 293 D motor driver...
i made a light tracker car and i used pic 16F877A , L 293D (motor driver), DC motor , and LDR
but unfortunately i don't know why the micro controller is always burning after work in 3 mn
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.