Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Designing a 50W two switch forward converter. The input voltage is 600V. On reset the transformer primary should clamp to the input bus voltage. On my prototype during reset the primary voltage reverses but only hits about 500V and never forward bias the clamp diodes. What could be going on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.