Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
resistors ads model
Dear all,
Please help me on the importing spectre model into ADS. I found the error as svcvs is underfined. Attached is part of file.
//
simulator lang=spectre insensitive=yes
section rf_res_device
//
subckt RESRFA_D1 (1 2 ref)
Rs1 (1 n1s1) resistor r=1e-3
Rs2 (2 n2s1)...
rf transmitter and reciver circut
Hi,
You should also look at this book especially on the systems and equations:-
RF Design Guide, by Peter Vizmuller, 1995
All the best.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.