Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi sunny55 i agree with mf1364 why not etch an copper claded board according to your ckt daigram.You can take professinal help for that, as it will make your things lot easier for you as you are using smd components.
Hi,GURGLAREN as per the picture you have posted. I think supply for the motor is given from the main power supply section through the lip switch,the lip switch will be on the mechanism of cassette player.Hence whenever play, forward, reverse buttons are pressed lip switch gets pressed to make...
Hello ballimo,
The charging of battery depends on charging voltage, charging current and battery type.If i want to charge a 6v battery the charger will give me 7.5v but the current will be in mA depending on the battery amps. Here in your case the other battery can give you full voltage but...
Hi there , for soldering of smd you require a hot air gun. I was using it to replace components of moblie phones.There are two settings for it first for temperture and second for air pressure . You have to mask the pad with solder material using micro solder iron then apply some flux to it...
Hello there,
I have M.B of gigabit GA-8I915ME, the problem is that after formatting the pc the pc becomes slow also i observed that its south chip (the chip between CMOS and RAM slot becomes very hot above normal ?
any suggestion please reply.......... bye
la-2922p.md
i santapg i have a query
i have gigabyte ga-8i 915me motherboard
the problem is that two of its cap 6.3v/3300uf has bulgout we donot get same value of cap what is the alternating value of cap that can be use
hi, if u don't get siemens batt u can try any other single cells available in the market
but mind that it should be of 1.2v u can open ur old pack and simply connect the new ones but look out 4r polaritys. bye
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
