Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
i have tried to buy max3372, lm3350 and QS3861 Ic's in Mumbai.
i have to interface aubtm-20(3.3v supply) with 8051(5v supply)
does anyone here know where i can buy these IC's or are there any alternatives to this.
level shifting is needed for UART communication betweeen autbm-20 and...
one more question
does giving 3.3v to aubtm-20
and 5v supply to max232 ic makes any compatiblity issue?
can i give 5v supply to aubtm-20? though 3.7v is highest rated voltage given in the document.
+++ is for bluesmirf bluetooth module, i guess.
also +++ is nowhere to be found in the aubtm's datasheet and At commands set.
Though I'll still try this out. thanks for your reply.
hello, friends
this is VIVEK M, from mumbai, a final year Electonics engg student, working on my Final year project.
I am using aubtm-20.
the problem I am facing is that i am not able to send AT commands from PC(hyperterminal) to aubtm-20.
hyperterminal settings: baud rate : 9600 bps, data...
hi jack,
this is vivek from mumbai.
I am using aubtm-20 for my Final year Graduate degree in Electronics Engg.
Jack, i am just not able to communicate(send AT commands) to aubtm from PC(hyperterminal winXP).
hyperterminal settings: baud rate : 9600 bps, data bits :8, stop bits: 1, parity: none...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
