Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need information about Analog ICs design automation.
What is Analog ICs design automation?
What ways are there for making the automation?
thanks in advance
I need to check the stability of a circuit in HSPICE.
How do I do the simulations for checking the stability of my circuit?
Do I have to break the loop? or
Could I do the AC analysis of the circuit without breaking the loop?
For getting the phase and gain margin do I have to break the loop...
what is a DC-DC converter?
what is a voltage regulator?
what is a voltage reference?
if you could upload a figure showing a power management system i would appreciate you........
thanks
Re: OPAMP
***********************************************************************************************************************
IN THIS CIRCUIT PLEASE SHOW: vin, vout, G and H
THANKS
opamp bandgap
how does the opamp gain affect the temperature coefficient (TC)?, in a bandgap reference source that use an OPAMP to ensure two nodes have the same voltage
thanks
thanks MSSN and Miguel Gaspar. I already understand ........
do you have papers, books or some document, where i can get the information that we discussed?,
i need bibliographic references of this information............
please upload them
thanks in advance
Is the difference between the tolerance values of two devices (resistors) in the same chip THE MISMATCH?
(Tolerance of R1) - (Tolerance of R2) = Mismatch between R1 y R2
thanks
Re: Opamp
vicky said:
Connecting the output of an op-amp to its inverting (-) input is called negative feedback. This term can be broadly applied to any dynamic system where the output signal is "fed back" to the input somehow so as to reach a point of equilibrium (balance).
Does the point...
How could i get the EXACT EFFECTIVE IMPEDANCE from the reference to the ground node of this bandgap reference?; and how could i get the EXACT EFFECTIVE IMPEDANCE from the reference to the input supply voltage of this bandgap reference?
How could i get the effective impedance from the reference to the ground node of this bandgap reference?; and how could i get the effective impedance from the reference to the input supply voltage of this bandgap reference?
Is exactly the effective impedance from the reference to the ground...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
