Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
how often do you run signal integrity to test your PCB. What kind of terminations do you use.
I draw PCB which have components with 1ns rise time.I import IBIS models and setup layer structure. Most of tracks are shorter than 40mm(1.5inch) and their with is 6mils. I run Signal...
Hi,
I am using Altium. I import ibis model but i don't know which technology I have to set.
I get issue about logic levels if I don't set technology. Does IBIS model contains data about technology?
I think that the IBIS model should contain logic levels.
How should I set SI-models to get...
Hi,
this is copied from AP0107 Impedance-Controlled Routing.pdf from Altium
The speed at which the electrical energy can travel along the route it known as the propagation velocity, where
VP = speed of light / √dielectric constant
Using
Time = 1/3 * rise time
εR = 4.7 (approximation for FR4)...
altium add net tie
Hi,
When I use Situs-auto router(Altium designer). I always get a lot of
What should I change to get less Short-Circuit Constraint. I use bga-footprint and under bga I get short-circuit.
r,S
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.